Opel Corsa Owners Manual: Battery voltage, Brake light switch, Drain diesel fuel filter, Lighting, Trip computer

Battery voltage

Low battery voltage in the radio remote control. On vehicles without check control, the message InSP3 appears in the instrument panel display. Replace the battery.

Brake light switch

Brake light does not come on during braking. Have the cause of the fault remedied immediately by
a workshop.

Drain diesel fuel filter

If there is water in the diesel fuel filter, the message InSP4 appears in the instrument panel display. Consult a workshop.

Lighting

Important exterior lighting lamps, including cables and fuses, are monitored. In trailer mode, trailer lighting is also monitored. Trailers with LED lighting must have an adapter that enables lamp monitoring as with conventional bulbs.

Lighting

The failed lighting will be indicated in the information display or the message InSP2 will appear in the instrument panel display.

Trip computer

Trip computer

The trip computer provides information on driving data, which is continually recorded and evaluated electronically.

The functions can be selected via the buttons on the wiper lever.

Turn the adjuster wheel to select: ■ Range.

■ Instantaneous consumption.

■ Distance travelled.

■ Average speed.

■ Absolute consumption.

■ Average consumption.

■ Stop watch.

Range

Range is calculated from current fuel tank content and instantaneous consumption. The display shows average values.

After refuelling, the range is updated automatically after a brief delay.

When the fuel level in the tank is low, a message appears on the display.

Confirm the warning message by pressing on the wiper lever.

Instantaneous consumption

Display of the instantaneous consumption. At low speeds, consumption per hour is displayed.

Distance travelled

Display of distance travelled.

Average speed

Display of average speed.

Stoppages in the journey with the ignition off are not included in the calculations.

Absolute consumption

Display of fuel consumed.

Average consumption

Display of average consumption.

Stop watch

Measurement of the time from activation to deactivation.

Press the button to start and
stop
the measurement.

Reset trip computer

The measurement or calculation of the following trip computer information can be restarted: ■ Distance,
■ Average speed,
■ Absolute consumption, ■ Average consumption.

Select the desired function. To reset a value to zero, hold down the button 7 for more than three seconds.

To reset all functions, hold down the button 7 for more than 6 seconds.