Opel Corsa Owners Manual: Adaptive forward lighting
Adaptive forward lighting
Headlights have separate systems for low beam 1 (outer bulbs) and high beam 2 (inner bulbs). The cornering light is also located behind the cover for the high beam.
Due to the complexity of the procedure, bulb changes should be carried out by a workshop.
Low beam
1. Disengage wire clip and remove protective cover 1.
2. Press base upwards and remove from reflector.
3. Detach plug connector from bulb.
4. Insert new bulb in reflector so that the locating tab of the bulb holder aligns with the reflector recess.
Attach the bulb holder so that the locating tab is on the side.
5. Engage bulb.
6. Attach connector to bulb.
7. Put on protective cover and engage wire clip.
High beam
1. Rotate protective cover 2 anticlockwise and remove.
2. Detach wiring plug from bulb.
3. Disengage spring clip from retainer by moving and swivelling to the side.
4. Remove bulb from reflector housing.
5. When installing the new bulb, insert lugs in the reflector recesses.
6. Install spring clip, plug connector onto bulb.
7. Install protective cover.
Cornering light
1. Rotate protective cover 2 anticlockwise and remove.
2. Detach wiring connector from bulb.
3. Disengage spring clip from retainer by moving and swivelling to the side.
4. Remove bulb from reflector housing.
5. When installing the new bulb, insert lugs in the reflector recesses.
6. Install spring clip, plug connector onto bulb.
7. Install protective cover.
Side lights
1. Rotate protective cover 2 anticlockwise and remove.
2. Withdraw side light bulb holder from reflector.
3. Remove bulb from socket and
renew bulb.
4. Insert holder in reflector. Install the protective cover.
Bulb replacement, Halogen headlights
Bulb replacement
Switch off the ignition and switch off
the relevant switch or close the doors.
Only hold a new bulb at the base! Do
not touch the bulb glass with bare
hands.
Us ...
Fog lights, Front turn signal lights, Tail lights
Fog lights
Have bulbs replaced by a workshop.
Front turn signal lights
Front turn signal lights
1. Rotate bulb holder anti-clockwise
to disengage.
2. Push bulb i ...
See also:
Opel Corsa B 1993–2000 Service and Repair Manual. Oil pressure warning light
switch/gauge sender -
removal and refitting
Removal
1. The switch/gauge sender is screwed into
the cylinder block or oil filter carrier
(depending on model).
2. Disconnect the battery negative lead and
disconnect the wiring from the switch ...
