Opel Corsa B 1993–2000 Service and Repair Manual: Pistons and connecting rods - removal and refitting
The piston crowns are not marked to show their direction of fitting, but the underside of the piston is (see illustration).
Large land (arrowed) faces the
flywheel end of the engine
Flywheel - removal and refitting
On 1.6 (16SV and C16NZ), 1.8 (18SE) and all 2.0 litre engines note that it will be necessary to remove the transmission or engine in order to remove the flywheel. On all engines, on refitting, use thread locking compound on the flywheel bolts and tighten them to the specified torque.
Oil pump - removal and
refitting
Removal
1. Remove the camshaft toothed belt and the sump.
2. Slacken and remove the crankshaft sprocket centre bolt and remove the
sprocket and spacers, noting their correct
fitted locations. Extr ...
Crankshaft front oil seal -
removal and refitting
Removal
1. Remove the camshaft toothed belt. On 1.6 (16SH),
1.8 and
2.0 litre models, note that it will also be
necessary to undo the crankshaft sprocket
centre bolt and
remove the sprocket and ...
See also:
Opel Corsa B 1993–2000 Service and Repair Manual. Rear axle assembly - removal
and refitting
Removal
1. Slacken the rear wheel bolts, raise and
support the rear of the vehicle and remove the rear
wheels.
2. On vehicles with a level control system,
depressurise it at the filling valve.
3 ...
