Opel Corsa B 1993–2000 Service and Repair Manual: Front anti-roll bar - removal and refitting
Removal
1. Raise and support the front of the vehicle.
2. Unbolt both ends of the anti-roll bar from the control arms (see illustration).
Front anti-roll bar end link
3. Unbolt the two brackets from the bulkhead.
4. Remove the anti-roll bar through one of the wheel arches, turning the steering wheel as necessary to obtain sufficient clearance.
5. Renew the rubber mountings as necessary.
Use a silicone-based lubricant on the bulkhead bracket bushes.
Refitting
6. When refitting, fasten the two brackets first; tightening their bolts to the specified torque.
7. Tighten the end mountings to achieve a dimension A, as shown using new self-locking nuts (see illustration).
Anti-roll bar cushion link setting
A = 38mm
8. Lower the vehicle when the anti-roll bar is secured.
Control arm bushes - renewal
1. Remove the control arm.
2. Press out the front bush using suitable
pieces of tube and a vice or a long bolt and
washers. The bush should be removed from
front to rear.
3. Fit the new front bus ...
Rear hub bearings - adjustment
Early (pre 1992) models
1. Chock the front wheels. engage a gear (or
P) and release the handbrake.
2. Remove the wheel trim. If the roadwheels
have no central hole, slacken the wheel bolts.
3. Ra ...
See also:
Opel Corsa B 1993–2000 Service and Repair Manual. Engine components -
examination and renovation
Camshaft
1. With the camshaft removed, examine the
bearings for signs of obvious wear and pitting.
If evident, a new camshaft housing will
probably be required.
2. The camshaft itself should sh ...
