Opel Corsa B 1993–2000 Service and Repair Manual: Front seat - removal and refitting
Removal
1. Remove the trim which covers the seat outboard rail. This trim is secured by a single self-tapping screw at the front (see illustration).
Seat rail trim removal
2. Remove the four bolts which secure the seat rails to the floor (see illustrations). Remove the seat, complete with rails; disconnecting the seat heating wires (when fitted).
Seat rail front retaining bolt
(one of two)
Seat rail rear retaining bolt
(one of two)
3. The seat can be separated from the rails if wished, for example if attention to the adjustment mechanisms is necessary.
Refitting
4. Refit in the reverse order to removal, but observe the following tightening sequence for the rail bolts:
- Nip up the rear bolts.
- Tighten the front bolts to the specified torque.
- Tighten the outboard rear bolt to the specified torque.
- Tighten the inboard rear bolt to the specified torque and refit the seat rail trim.
Exterior rear view mirror
components - removal and
refitting
Mirror glass
1. On all types, the mirror glass may be
renewed separately.
2. Prise out the old glass (if intact) with a
wooden wedge, and when applicable
disconnect the electrical cables. Engage ...
Head restraints - removal and
refitting
Removal
1. Both front and rear head restraints are
removed in the same way.
2. Pull the head restraint up as far as it will go.
3. Release the catch spring by pushing it
rearwards and remove the ...
See also:
Opel Corsa B 1993–2000 Service and Repair Manual. Unleaded petrol - general
information and usage
Note: The information given in this Chapter is
correct at the time of writing and applies only to petrols currently available in the UK. If updated
information is thought to be required check
with ...
