Opel Corsa B 1993–2000 Service and Repair Manual: Centre console - removal and refitting
Removal
1. The centre console is in two parts: the rear half, surrounding the handbrake lever, and the front half, which sits below the heater controls.
2. Commence removal with the rear half. Prise out the screw cover and remove the securing screw (see illustrations).
Centre console rear half screw cover
Removing the centre console rear
half screw
3. Slide the console rearwards to free it.
Removal of the front half may proceed without further disturbing the rear; to remove the rear half completely, disconnect or remove any switches from it and lift it over the handbrake lever.
4. Unclip the cover from around the base of the gear lever. There is no need to remove the gear lever boot itself. Undo the two screws to front and rear of the gear lever (see illustrations). On automatic transmission versions, remove the selector lever cover.
Centre console screw (arrowed) to
rear of gear lever
Centre console screw (arrowed) in
front of gear lever
5. Release the two retaining clips and remove the oddments box from below the heater control panel.
6. Remove the two screws which secure the console to the heater control panel (see illustration). Withdraw the console.
Centre console screw (arrowed)
below heater control panel
Refitting
7. Refit in the reverse order to removal.
Glovebox - removal and refitting
Removal
1. Open the glovebox and prise out the two check strap plugs (see illustration).
Glovebox check strap disconnected
2. Support the glovebox and remove the two hinge bolts (see illustration). The glovebox can now be removed.
Glovebox hinge bolt
Refitting
3. Refit in the reverse order to removal. Note that the hinge bolt holes are slotted to allow for fine adjustment when fitting.
Rear seat - removal and
refitting
Removal
1. Uncover the hinges at the front of the seat.
Free them by extracting the circlips and
removing the hinge pins (see illustration).
The bench section(s) of the seat can now be
remove ...
Seat belts - general
Warning: If the vehicle has been
involved in an accident in which
structural damage was
sustained all the seat belt
components must be renewed.
1. Inertia reel front seat belts are fitted to all
...
See also:
Opel Corsa B 1993–2000 Service and Repair Manual. Window lifting mechanism -
removal and refitting
Removal
1. Remove the door trim panel.
2. Various types of mechanism may be fitted:
scissors or cable, manual or electric. In all
cases the principles of removal are similar.
The electric motor ...
